28
Changing pre-set options
Wash temperatures
All wash temperatures can be individually adjusted if you think they are too hot or too cold.
Note: the hot temperature will be the same as the hot water supply temperature.
To modify the wash temperature:
1
Enter Option Adjustment mode (refer to page 26).
2
Select the HEAVY cycle.
3
Select the wash temperature you want to adjust, eg WARM, by touching the WASH TEMP button.
The digital display screen shows the current setting.
4
Touch the MORE or LESS button to increase or decrease to the desired temperature. Each
increment is equal to approximately 0.5°C.
Fig.20 Adjusting the temperature setting, eg increasing the WARM wash temperature
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
Controlled cold
If your incoming cold water temperature is very low you will get a less effective wash. The
CONTROLLED COLD option solves this problem by adding a small amount of hot water to raise
the temperature of the wash to approximately 20°C.
To programme the CONTROLLED COLD temperature option:
1
Enter Option Adjustment mode (refer to page 26).
2
Select the HEAVY cycle.
3
Select COLD wash temperature by using the WASH TEMP button (if not already selected).
4
The digital display shows the temperature adjustment possible. The default setting is “tAP”,
iethe temperature of the incoming water from the cold cylinder.
Touch the MORE
button until “O” is displayed. Your washer will now control the cold
temperature to approximately 20°C. Note: each of the remaining settings equals an
approximate increase or decrease of 0.5°C from this point.
Fig.21 Changing the Cold wash temperature setting to Controlled Cold
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
Note: if you always use COLD or CONTROLLED COLD water, we recommend that a WARM or
HOT wash be used regularly, eg every 5th wash should be at least a warm one to maintain the
cleanliness of your machine.
To Next Page
Loading...
Need help?
General
