Fisher Scientific Accumet Basic AB30 - Unpacking the Accumet AB30 Meter

TABLE OF CONTENTS
1 INTRODUCTION
1
2 UNPACKING THE METER
2
3 GETTING STARTED
3
3.1 Connectors 3
4 USING THE METER
5
4.1 Conductivity Probes 5
4.2 Display/ Keys 7
4.3 Screen Display 8
5 CONDUCTIVITY OPERATION
9
5.1 Using Setup 9
5.1.1 Using setup from the measure screen 10
5.1.2 Program 1: View the calculated cell constant 12
5.1.3 Program 2: View the standardized value 13
5.1.4 Program 3: Select the conductivity mode 14
5.1.5 Program 4: Select resistivity mode 14
5.1.6 Program 5: Select the TDS mode 14
5.1.7 Program 6: Select the cell constant (1.00) 15
5.1.8 Program 7: Select the cell constant (10.00) 15
5.1.9 Program 8: Select the cell constant (0.10) 15
5.1.10 Program 9: Select the temperature coefficient (2.0%)
16
5.1.11 Program 10: Select the temperature coefficient (5.2%) 17
5.1.12 Program 11: Select the temperature coefficient (0.0%) 17
5.1.13 Program 12: Select the temperature coefficient (1.5%) 19
5.1.14 Program 13: Select the TDS Factor (0.40 Ð 1.00) 20
5.1.15 Program 14: Temperature unit selection (¡C) 21
5.1.16 Program 15: Temperature unit selection (¡F) 21
5.1.17 Program 16: Enable the STABLE icon 22
5.1.18 Program 17: Disable the STABLE icon 23
6 STANDARDIZATION
25
6.1 Using Setup 25
7 MEASUREMENT
28
7.1 Conductivity Measurement 28
7.2 Resistivity Measurement 30
7.3 TDS Measurement 31
7.4 Temperature Measurement 31
8 CONDUCTIVITY OPERATION
33
8.1 Replatinization 33
9 CONDUCTIVITY THEORY
34
10 CLEANING
38
11 METER SPECIFICATIONS
38
1 2 WARRANTY
40