5 CONDUCTIVITY OPERATION
5.1 Using Setup
Setup allows you to set the operating parameters of the meter to
meet your requirements. There are two ways to access setup, and
the parameters that you can set will be different depending on how
you accessed setup. Determine which access route you need to
utilize from the chart below:
To set the following parameter
Access Setup from the following
screen
Select the type of measurement
you wish to make (conductivity,
resistivity or TDS) and associated
units.
From the Measure Screen
View the calibrated cell constant From the Measure Screen
View the last calibrated buffer
value
From the Measure Screen
Select Cell constant From the Measure Screen
Select Temperature coefficients From the Measure Screen
Selecting the TDS factor From the Measure Screen
Select Temperature units From the Measure Screen
Clear the user calibration From the Measure Screen
Conductivity standard solution From the Standardize Screen
To Next Page
Loading...
