Need help?Do you have a question about the Fisher Scientific Accumet Basic AB30 and is the answer not in the manual?
General| pH Resolution | 0.01 pH |
|---|---|
| pH Accuracy | ±0.01 pH |
| mV Range | ±1999 mV |
| mV Resolution | 1 mV |
| mV Accuracy | ±1 mV |
| Temperature Range | -5.0 to 105.0 °C |
| Temperature Resolution | 0.1 °C |
| Temperature Accuracy | ±0.5 °C |
| Display | LCD |
| Auto Shut-off | Yes |
| Calibration Points | Up to 3 points |
Explains the layout and function of the rear connector panel on the meter.
Describes how to connect and prepare 2-cell and 4-cell conductivity probes.
Overviews the meter's screen display and the function of its keys.
Familiarizes the user with the layout and elements of the digital screen display.
Explains how to access and configure operating parameters for the meter.
Describes navigating and changing parameters within the setup menu from the measure screen.
Instructs on how to view the stored cell constant value in the meter's memory.
Guides the user on how to check the last standardized value recorded by the meter.
Explains how to choose and set the conductivity measurement mode.
Details the process for selecting and setting the resistivity measurement mode.
Covers how to select and configure the Total Dissolved Solids (TDS) measurement mode.
Shows how to set the nominal cell constant to 1.00 for measurements.
Guides on setting the nominal cell constant to 10.00 for measurements.
Explains how to set the nominal cell constant to 0.10 for measurements.
Details how to select a 2.0% temperature coefficient for compensation.
Guides on selecting a 5.2% temperature coefficient for compensation.
Explains how to select a 0.0% temperature coefficient for compensation.
Covers selecting a 1.5% temperature coefficient for compensation.
Instructs on adjusting the TDS factor within the specified range.
Describes how to set the temperature unit to Celsius (°C).
Guides on setting the temperature unit to Fahrenheit (°F).
Explains how to turn on the STABLE icon for reading stability indication.
Details how to turn off the STABLE icon display.
Guides on resetting or clearing the meter's calibration data.
Explains how to use the setup menu to prepare for standardization.
Describes the standardization procedures for resistivity and TDS modes.
Details the steps for taking conductivity measurements with the meter.
Explains how to perform resistivity measurements using the device.
Covers the procedure for taking Total Dissolved Solids (TDS) measurements.
Describes how the meter handles temperature readings and ATC calibration.
Explains the process of replatinizing the conductivity probe to maintain performance.
Discusses the advantages and operation of the four-cell electrode design.
Explains the relationship between conductivity and temperature, and compensation methods.
Provides a list of specific replacement parts for the meter and accessories.
To Next Page
