std
p
stdby
setup
enter
5.1.1 Using setup from the measure screen
If you are currently viewing the Setup screen, setup is in essence
a scroll button which allows you to access, view, and change a
variety of operating parameters. While in setup, you may:
Press std to exit from setup to measure screen
without making change.
Press setup to scroll to the next parameter to
view or change.
Press π to set values within each setup option.
Press enter to accept the displayed parameter.
The meter will then return to the measurement
mode.
Press stdby to return to the stdby mode without
making a change. Pressing stdby again will
place the meter in the Measure mode.
To Next Page
Loading...
