Fisher Controls
Change 2 Instructions for . . .
UM6.1 :DPR900:9102
DPRSOO Integral Controller
User Manual
(Original -
May 1991)
(Change 1 - September 1991)
The following information and attachments constitute Change 2 to the
DPRSOO Integral Controller User Manual, UM6.1:DPR900:9102. Vertical
change bars are used to highlight the material affected by this change.
How to Insert This Change
1. Remove title page and insert Change 2 title page.
2. Remove the Table of Contents and replace it with the new TOC
3. Insert Page A/B, List of Effective Pages at the end of the table of
contents.
4. Remove page l-3/14 and insert changed page l-3/1-4
Page 14 has an addition to the digital output signals for ac power.
5. Remove page 2-3/24 and insert changed page 2-3/24.
On page 24 the power connections for an ac-powered DPR910 are
relocated.
6. Remove pages 2-11 thru 2-16 and insert changed pages 2-11 thru
2-l 6.
A note regarding power usage has been added to page 2-11. The
38V value is added to the drawing on page 2-12. Subsection 2.13 on
page 2-14 is upgraded.
7. Remove pages 5-l 7 thru 5-22 and insert changed pages 5-l 7 thru
5-22.
On page 5-17, a notation has been added to the end of subsection
5.6.3.1 regarding DO3 and D04. On page 5-19, a sentence has been
added at the end of the page. On page 5-20, a footnote has been
added to the FCODE 103 options and the next to last paragraph has
been changed. A sentence has been added near the top of page
5-21.
Change 2 -July 1992
UMfi.l:DPR900:9147
To Next Page
Loading...
