August 10, 2005 12 Lit. No. 13648/9511, Rev. 07
BLAST
ON
OFF
SPINNER
Spinner Indicator Light
(Illuminated light indicates
power to the motor.)
On/Off Control Switch
(Emergency stop when
required.)
WARNING
Before starting the spreader, the driver shall
verify all bystanders are a minimum of 25 feet
away from operating spreader.
ON/OFF Control
Starting and Stopping the Motor
1. Move the power switch to the ON position to start
the motor. Motor will start immediately. The power
switch will remain in this position.
2. Move the power switch the the OFF position to
stop the motor. The power switch will remain in
this position. The power switch OFF position
operates as emergency stop when required.
NOTE: The truck ignition must be on to start the
spreader.
NOTE: If the truck ignition is turned off while the
spreader is running, the motor will stop.
Blast/Maximum Speed
Move and hold the power switch to the BLAST position
for as long as maximum speed is needed. When
released, the switch will automatically return to the
OFF position and stop the motor.
If there are problems while operating the spreader,
refer to the Troubleshooting section in this manual.
NOTE: Always place the cover on the hopper to
prevent moisture buildup. Do not let the spreader
sit idle with material in the hopper for an extended
period of time. This can cause the material to
compact and reduce or stop the flow of material.
To Next Page
Loading...
Need help?
General
