Fisher Speed-Caster - Removing the Spreader; In-Bed Mount Removal

Lit. No. 13648/9511, Rev. 07 13 August 10, 2005
REMOVING THE SPREADER
In-Bed Mount
NOTE: Empty the hopper before removing the
spreader.
1. Disconnect the spreader wiring harness from the
vehicle wiring harness.
NOTE: Grease the electrical connections using
dielectric grease.
2. Install the plug cover over the vehicle harness
plug.
3. Remove the hairpin cotter pins and hold-down
pins.
Spreader Wiring Harness
Vehicle Wiring Harness
Hold-down
Bolt
Hairpin Cotter
Pin
Hold-down
Pin
4. Using a hoist or two people, tip the hopper
assembly forward and lift it off of the mount
assembly.
5. Loosen and remove the hold-down bolts from the
front of the mount assembly.
6. Remove the mount assembly from the vehicle.
7. Install the tailgate.