Lit. No. 13648/9511, Rev. 07 21 August 10, 2005
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTION
Ice control material not flowing
(Spinner is turning.)
1. Bridging of material or obstruction
in hopper.
1. Unplug the spreader harness
and tag out if required. Check
hopper for material and free any
bridged material or obstruction.
Spread pattern not optimum
1. Deflector out of adjustment. 1. Unplug the spreader harness
and tag out, if required. Change
deflector adjustment to suit
desired pattern. See Adjusting
Gates and Deflector in the
Operating Section of this manual.
To Next Page
Loading...
