FLASHFORGE 3D PRINTER Dreamer NX - Page 21

Dreamer NX User Guide | www.flashforge.com
22
(4-9) Tap [Filament]-[Load].
4-10
(4-10) Wait for the extruder to heat up to the operating temperature. The
extruder will alert you once it reaches the operating temperature. Load the
filament by inserting it into the extruder at an upright angle.
4-11
(4-11) Filament will start to be extruded out of the nozzle. Continue loading to
ensure that the filament is being extruded in a straight line. Then tap [Done] to
finish loading.
4-9