FLASHFORGE 3D PRINTER Dreamer NX - Page 22

Dreamer NX User Guide | www.flashforge.com
23
Unloading filament:
Open the lid of the Dreamer NX
4-12
(4-12) Tap [Tool] in the homepage.
(4-13) Tap [Filament]- [Unload].
4-14
（ 4-14 ） Wait for the extruder to heat up to the operating temperature. The
extruder will alert you once it reaches the operating temperature. Press the
spring presser, press down the filament for about three seconds and gently
pull the filament out. Then tap [Done] to finish unloading.
4-13