Dreamer NX User Guide | www.flashforge.com
6.2.10 Supports
After loading the model, click [Edit]--[Supports] or click the Supports icon
directly, then you will enter the support edit mode (6-11). Click [Back] to exit
Click the Support Options, an option box will appear, supports options include
“treelike” and “linear”, when choose “treelike”, click [OK], then it will generate
treelike structure; when choose “linear”, click [OK], then it will generate linear
structure; if it is a model with supports, when you choose one of the supports
options, software will judge whether existing supports need to be deleted or
not on the basis of the type of existing support, and will pop up the
corresponding prompt to let you make the choice.
To Next Page
Loading...
