Dreamer NX User Guide | www.flashforge.com
② Auto Supports
Click the [Auto Supports] button, the software will judge the position where
supports are needed and generate corresponding treelike or linear supports. If
it is a model with supports, the existing supports will be deleted and new
supports will be generated.
Supports will be added once clicking the [Add] button. Move the cursor to the
position where supports needed, left-click to choose the starting point of
supports, hold down the left mouse button and drag the mouse, the supports
preview will show up (if support surface doesn’t need support or the support
column angle is too large, the support review will be highlighted).Loosen the
left mouse button, if support column doesn’t meet with model, then support will
be generated on origin and terminal point (the highlighted preview support
To Next Page
Loading...
