FLASHFORGE 3D PRINTER Dreamer NX - Edit Menu Functions

Dreamer NX User Guide | www.flashforge.com
46
6.2.13 Edit Menus
① Undo
Allows users to undo the recent edits by the following two methods:
Method 1: Click [Edit]--[Undo].
Method 2: Press the shortcut Ctrl+Z.
② Redo
Allows users to redo the most recent edit you have undone to your model file
by the following two methods
Method 1: Click [Edit]--[Redo]
Method 2: Press the shortcut Ctrl+Y.
③Empty Undo-stack
To clean up the recorded operating steps so as to release the memory.
④ Select All
By the following two methods, you could select all models in the scene.(When
models are too small to be seen or out of viewing scope, please click [Center]
and [Scale] buttons to adjust the model.)
Method 1: Click [Edit]--[Select All].
Method 2: Press the shortcut Ctrl+A.
⑤ Duplicate
Select the object and duplicate the object through the following two methods:
Method 1: Click [Edit]--[Duplicate]
Method 2: Press the shortcut Ctrl+D
⑥ Delete
Select the object and delete the object through the following two methods:
Method 1: Click [Edit]--[Delete]
Method 2: Press the shortcut Delete