Dreamer NX User Guide | www.flashforge.com
⑦ Auto Layout All
Click [Edit]--[Auto Layout All] after loading one or more than one models, all
models will be placed automatically as automatic placement rule.
Click [Edit]--[Repair Models] to repair models.
Click [Edit]--[Supports] to enter supports setting interface.
You can connect the Dreamer NX with your PC via a USB cable or WiFi.
Note: The machine icon on the bottom right displays the connection status:
Method 1：Connect Via USB Cable
a. Connect your Dreamer NXwith your PC via an USB cable.
b. Turn on your Dreamer NX and start FlashPrint.
c. Click [Print]--[Connect Machine], then select USB in the [Connection
Mode] option and select machine you want to connect in [Select Machine]
option. If you can not find your machine, click the [Rescan] button to scan your
machine and select it. Finally click [Connect] button to connect to the printer. If
you still can not find your machine after rescan, it means you haven’t installed
the driver in the software.
To Next Page
Loading...
