Dreamer NX User Guide | www.flashforge.com
● Temperature Control: Input the temperature you want to get in the left
frame, click [Apply], the printer will automatically heat the corresponding part,
the right side shows the current actual temperature of corresponding part. After
start heating, the below curve of temperature form will start to change, different
color correspond with different parts’ temperatures
Every time when you start FlashPrint, it will automatically detect and download
the up-to-date firmware. If any update is available, a dialog box will pop up for
reminding the users to update.
Step 1: Click [Tools]--[Update firmware]. It needs to cut off connection
before updating firmware. If software and printer are already in connection, it
will remind you cutting off the connection. Then choose [Yes] and go on to the
Step 2: Choose corresponding printer type and firmware version and click [OK]
in the firmware updating box. After confirming the printer is in free state, the
software will automatically update the firmware.
Step 3：Reboot you Dreamer NX and wait for 4-5 seconds, then you can see
the update process bar. When the update finishes, it will go back to the main
Step 4：Tap [Tools]--[About] to check whether the updated version is right.
③ On Board Preferences
When the computer and printer are in connection, click [Tools]--[On Board
Preferences], you can check the printer name.
④ Machine information
When the computer and printer are in connection state, click
[Tools]--[Machine information], you can check the machine type, machine
To Next Page
Loading...
