Dreamer NX User Guide | www.flashforge.com
Tap the [Preheat] button to enter the
preheat interface. Tap the [Start]
button to heat up to the setting
temperature.
The default temperature is 230℃.
Tap the temperature display bar to
set the temperature.
To set the preheat temperature.
Tap [Yes] to save the setting while
tap [No] to cancel the setting.
The picture displays the preheat
interface. It shows the actual
temperature and the target
temperature. Tap the [Stop] button
to abort the preheat job.
To Next Page
Loading...
