Dreamer NX User Guide | www.flashforge.com
9. After the gcode is done uploading, the printer will go preheating. The
Dreamer NX will begin printing once it has finished preheating.
1. Click [Print], and a printing options screen will show up.
2. Make sure that the “Material Left” is selected as “PLA”. Advanced
settings can be set under [More Options] icon.
3. Click [OK], and save the gcode file in the SD card.
4. FlashPrint will begin slicing the 3D model.
5. After slicing the object, take the SD card out from the computer. Insert it into
the SD card slot onto the Dreamer NX.
6. Turn on the Dreamer NX. Make sure the build plate is leveled and filament is
loaded on the left extruder.
7. Tap [Print] and then tap the middle SD Card icon.
8. A list of file(s) will show up, tap the file that you would like to print, and tap
9. The printer will now enter preheating and will start printing once it finishes
1. Turn on Dreamer NX. Make sure the build plate is leveled and filament is
loaded on the left extruder
2. Turn on Wi-Fi on the Dreamer NX. Then tap [Tool]-[Setting]-[WiFi]-[WiFi
3. A connection called “USR-WiFi232-G2” can be found on the list of available
networks. Connect your PC to this network.
4. Open your Internet browser. Type in “10.10.100.254” and tap [Enter] on
your keyboard. Enter the username and password to login. The default
To Next Page
Loading...
