Flashforge Creator Pro - Accessories; Included Accessories List

(1)
(2)
(3)
(4)
Filament Guide Tube and Filament Installation
(1) To install a spool holder, level it and insert the end into
the corresponding opening.
(2) Turn down the spool holder to make the holder bottom
cleave to the printer back.
(3) Take a roll of ABS filament, then squeeze the spool
holder top and mount the filament spool to the holder.
(4) Lock the filament guide tube with R-shape buckles.
Please refer to the next page
for the right method of
filament mounting
Filament Guide
Tube Buckle