Loading a png, jpg, jpeg, bmp picture file into the FlashPrint. And the following dialogue box(5-3)
will pop up. The setting box includes settings for shape, mode, maximum thickness, base thickness,
bottom thickness,width, height, top diameter and bottom diameter.
Shape: including plane, tube, canister and lamp.
Mode: including “darker is higher”and “lighter is higher”.
Maximum thickness: Z value of the model
Base thickness: The minimum raft thickness and the default value is 0.5mm
Width: X value of the model
Depth: Y value of the model
Bottom thickness: For tube, canister and lamp to set up bottom thickness
Top diameter: For tube, canister and lamp to set up the top diameter
Bottom diameter: For tube, canister and lamp to set up the bottom diameter
To Next Page
Loading...
