Click the [View] icon and then you can rotate the object by the following two methods:
Method 1. Hold down the right mouse button and drag.
Method 2. Hold down the Shift key, hold down the left mouse button and drag.
Rotate the mouse wheel to enlarge or shrink the build plate.
Allows users to view the object on the build plate. Six views are under the view menu, that is, home
view, bottom view, top view, front view, back view, left view and right view.
Method 1: Click the the [View] button, there are six views in the drop- down list
Method 2: Click the the [Look] icon on the left, click it again and a submenu will appear
with six views for selecting.
Allow users to reset views by the following two methods:
Method 1: Click the [View] menu and select [Home View]
Method 2: Click the [View] button on the left, click it again and you will see the viewing options,
Click [View]--[Show Model Outline], it will highlight the yellow border of the object
Click [View]--[Show Steep Overhang]. When the intersection angle between the model surface
and horizontal line is within the overhang threshold value, the surface has steep overhang and it
becomes red in the software. Overhang threshold value could be set as needed. The default value is
To Next Page
Loading...
