————————————————————————————————————————————
Method 1: Click [Edit]--[Delete]
Method 2: Press the shortcut Delete
Auto Layout All
Click [Edit]--[Auto Layout All] after loading one or more than one models, all models will be
placed automatically as automatic placement rule.
Surface to Platform
After selecting the model, you can make the model surface to platform via the following
operation.
Click [Edit]--[Surface to Platform] into surface to platform mode
Select one surface of model, double left-click the surface, then the model will be placed
automatically with the selected surface to platform.
Supports
After loading the model, click [Edit]--[Supports] or click the Supports icon ( ) directly, then you
will enter the support edit mode (as shown in the picture below). Click [Back] to exit when you
finish editing.
Auto Supports
Click the [Auto Supports] button, the software will judge the position where supports are needed
and generate corresponding treelike or linear supports. If the model already had support, the
existing supports will be deleted and new supports will be generated.
Clear Supports
Click [Clear Supports], all supports will be deleted. The operation can be repealed via clicking
[Undo] or pressing the shortcut key Ctrl+Z.
To Next Page
Loading...
