————————————————————————————————————————————
Unpacking Your Finder
1. Place the packaging box on a clean work surface. Open the box, grasp the two handles and
then lift your Finder out of the box.
2. Removing the protective foam sheets at two sides, you will see the Finder in a transparent
nylon bag. Then remove the bag to unveil the Finder.
3. On the top foam sheet, you can see the Quick Start Guide, 4GB USB stick, three Allen wrenches
(M1.5, 2 and 2.5) and one screwdriver.
4. Removing the top foam sheet, you will see the extruder and X-axis guide rods which are held
To Next Page
Loading...
