15
R2 Wireless Flash Operation
The eVOLV200 adopts the R2 2.4G wireless radio system, which has absolute compatibility with
other R2 Family ashes and transmitters. As a slave unit, the eVOLV 200 senses and switches
automatically to be compatible with Canon, Nikon, and Sony R2 TTL according to the master unit
employed.
Nikon cameras (use R2T-N), Canon cameras (use R2T-C) and Sony cameras (use R2T-S) can use one
or more eVOLV 200-TTL ashes simultaneously.
The EVOLV200 can only be set as slave unit (R2 receiver or Optical S1/S2). Long press the wireless
selection button (gE/21) for 2 seconds to switch the radio transmission function on or o. See the
Manual Flash Operation section for Optical Slave instructions.
B. Setting the Communication
Channel
In order to prevent signal interference from
other wireless ash systems nearby, you can
change the channel IDs. The channel IDs of the
master unit and the slave unit(s) must be set to
the same value.
1. Long press the < GR/CH > Button for 2
seconds, so that the icon will be displayed
on the LCD panel.
2. Turn the Select Dial to choose a channel ID value
from 1 to 32.
3. Press the < SET > button to conrm.
Setting the Communication Group
Short press the < GR/CH > button to choose group ID
value from A to E.
Wireless Mode Flash Mode
OFF M / Multi
Radio Transmission TTL / M / Multi
A. R2 Wireless Settings
Long press < > button for 2
seconds to switch wireless function ON/ OFF.
Turn the wireless function on, the < >
icon will be displayed on the LCD panel.
When using the R1 remote control or others
trigger, please turn o the wireless function.
To Next Page
Loading...
