FlashPoint eVOLV 200 R2 - Modular Flash Head Attachment; Attaching the Bare Bulb Head; Attaching the Fresnel Speedlite Head

9
1. Start with a removing an attached ash
head by the sliding catch lock to the left (g
B / 11) and pulling gently on the head to slip
it o the mounting plate of the eVOLV200
body.
2. Remove the reector or other accessories
from the ash head b efore mounting it on
the eVOLV200 body.
3. The modular Barebulb ash head locks into
the eVOLV200 body by lining up the pins on
the head to the sockets of the eVOLV200
(g H & I) and sliding the head down,
engaging the head to the body. The lock
automatically closes.
4. Take the Barebulb ashtube and align the
pins of the tube carefully with the tube
socket by matching the 3 pins on the base of
the ash tube with the 3 sockets in the Tube
Socket (g J & K). Push the ash tube in until
it is securely seated into the socket.
5. You have the option to attach a reector
or any Streaklight light modier on to the
Barebulb head socket surrounding the
ashtube socket. The knob on the side of the
module (g J) locks and unlocks the add-on
accessory with a twist right or left.
Speedlite and Bare Bulb Modular Flash Heads
Figure H Figure J
Figure I
Figure K
Attaching the Bare Bulb Flash Head
Attaching the Fresnel Speedlite Flash Head
1. Start with a removing an attached ash
head by the sliding catch lock to the left (g
B / 11) and pulling gently on the head to slip
it o the mounting plate of the eVOLV200
body.
2. The modular Fresnel Speedlite ash head
locks into the eVOLV200 body by lining up
the pins on the head to the sockets of the
eVOLV (g H & I) and sliding the head down,
engaging the head to the body. The lock
automatically closes.