FlashPoint eVOLV 200 R2 - Temperature Protection Functionality; Over-Temperature Protection Limits; High-Speed Sync Overheating Considerations

19
Temperature Protection Function
• To avoid overheating and deteriorating the ash heads, do not re more than 100 continuous
ashes in fast succession at 1/1 full power. After 100 continuous ashes, allow a rest time of at
least 10 minutes.
• If you re more than 100 continuous ashes and then re more ashes in short intervals, the inner
over-temperature protection function may be activated and alter the recycling time to over 10
seconds to protect the circuitry. If this occurs, allow a rest time of about 10 minutes, and the ash
unit will then return to normal operation.
• When the overheat protection is triggered by high temperatures, icon is shown on the LCD
display.
Power Output Level
Number of Flashes
Speedlite Flash Head Bare bulb Flash Head
1/1 40 60
1/2 (+0.3,+0.7) 50 80
1/4 (+0.3,+0.7) 60 100
1/8 (+0.3,+0.7) 100 150
1/16 (+0.3,+0.7) 200 200
1/32 (+0.3,+0.7) 300 300
1/64 (+0.3,+0.7)
1/128 (+0.3,+0.7)
500 500
Power Output Level
Number of Flashes
Speedlite Flash Head Bare bulb Flash Head
1/1 40 50
1/2 (+0.3,+0.7) 50 60
1/4 (+0.3,+0.7) 60 75
1/8 (+0.3,+0.7) 75 100
1/16 (+0.3,+0.7)
1/32 (+0.3,+0.7)
80 150
1/64 (+0.3,+0.7)
1/128 (+0.3,+0.7)
100 200
Number of ashes that will activate over-temperature protection:
Number of ashes that will activate over-temperature protection
in high-speed sync triggering mode: