How to stop continuous drain flow in Fleck Control Unit?
To stop continuous drain flow in your Fleck Control Unit, remove the piston assembly and inspect the bore, removing any foreign material, and check the valve in various regeneration positions. You may also need to replace seals spacers and or the piston assembly, replace the timer motor and check all gears for missing teeth or replace the timer.
General| Brand | Fleck |
|---|---|
| Model | 7700 |
| Category | Control Unit |
| Language | English |
Minimum and maximum water pressure requirements for effective valve operation.
Covers site selection, plumbing, tube preparation, lubrication, and initial flushing.
Instructions for connecting power, purging air from the unit, and initial valve cycle.
Procedures for initiating regeneration manually via button presses.
Information and caution regarding the valve's programming mode.
Select regeneration trigger: time clock, metered immediate, or metered delayed.
Input system capacity in Kilo grain (US) or m³x°tH (metrical).
Set water hardness in grain (US) or metrical format (french degrees).
Set the specific time of day for automatic regeneration, e.g., 2 A.M.
To Next Page
