FLEETBOARD DispoPilot.Guide - Route Options; Vehicle Dimensions; Vehicle Profile

R
Ignore limitations
R
Hazard class
X
Select the General menu.
X
Select the Check vehicle settings
when navigation starts. menu.
X
To activate the function: tick O the box.
Press the ÷ button to confirm.
Setting the route options
Use this function to select the route optimi-
sation to be used by FleetBoard
®
Navigation.
X
Select the Route profile menu.
X
Select the Route options menu.
X
To select the desired setting: activate the
O tick next to the desired setting.
R
Most
practical route incl. motor‐
way: special truck conditions are inclu-
ded.
R
Most practical route & limited
motorway use: the use of routes includ-
ing sections of motorway is avoided
where possible.
R
Shortest route incl. motorway: the
shortest route is calculated.
R
Shortest route & avoid motorway:
the shortest route is calculated, while
avoiding routes including sections of
motorway where possible.
Including toll roads
Use this function to determine whether Fleet-
Board
®
Navigation includes special toll roads
(e.g. tunnels, mountain pass roads, bridges)
in the route calculation.
X
Select the Route profile menu.
X
Select the Toll roads menu.
X
To activate the function: tick O the box
X
Press the ÷ button to confirm.
Including ferries
Use this function to determine whether Fleet-
Board
®
Navigation includes ferries in the
route calculation.
X
Select the Route profile menu.
X
Select the Ferries menu.
X
To activate the function: tick O the box.
X
Press the ÷ button to confirm.
Vehicle profile
Use this setting to adjust the navigation cal-
culations to the vehicle type (HGV or van).
This improves the accuracy of the navigation
calculations.
X
Select the Vehicle profile menu.
X
To select the desired setting: activate the
î selection field next to the desired set-
ting.
X
Press the ÷ button to confirm.
Entering the vehicle height
Use this function to enter the height of the
vehicle,
so that the DispoPilot navigation sys-
tem avoids route sections with low headroom
clearance.
X
Select the Height (truck)/Height
(van) menu.
X
Enter the height of the vehicle.
X
Press the ÷ button to confirm.
Entering the vehicle width
Use this function to enter the width of the
vehicle,
so that the DispoPilot navigation sys-
tem avoids route sections with narrow roads.
X
Select the Width (truck)/Width (van)
menu.
X
Enter the width of the vehicle.
X
Press the ÷ button to confirm.
DispoPilot settings
13
Overview and operation
Z