FLEETBOARD DispoPilot.Guide - Vehicle Weight

Entering the vehicle length
Use this function to enter the length of the
vehicle. The DispoPilot navigation system
then
avoids route sections which are not suit-
able for long vehicles.
X
Select the Length (truck)/Length
(van) menu.
X
Enter the length of the vehicle.
X
Press the ÷ button to confirm.
Entering the actual gross vehicle
weight
Use this function to enter the actual gross
weight of the vehicle. The DispoPilot naviga-
tion
system then avoids route sections which
are not suitable for heavy vehicles.
X
Select the Actual total weight
(truck)/Actual total weight (van)
menu.
X
Enter the actual gross vehicle weight.
X
Press the ÷ button to confirm.
Maximum axle weight
Use this function to enter the maximum axle
weight of the vehicle. The DispoPilot naviga-
tion system avoids route sections which are
not suitable for vehicles with a high axle
weight.
X
Select the Maximum axle weight menu.
X
Enter the maximum axle weight.
X
Press the ÷ button to confirm.
Ignore limitations
Using this function, you can select whether or
not
to ignore limitations which may exist due
to the following vehicle parameters:
R
vehicle length
R
vehicle width
R
vehicle height
R
vehicle weight
R
further parameters
Hazard class
Using this function, you can enter the hazard
class of the load. The DispoPilot navigation
system will then avoid route sections on
which the transportation of hazardous mate-
rials is not permitted.
You can select the following hazard classes:
R
none
R
hazardous materials
R
explosive materials
R
combustible materials
R
detrimental to water quality
X
Select the Hazard class menu.
X
To select the desired setting: tick O the
box next to the desired setting.
X
Press the ÷ button to confirm.
Logistics settings
The following menus are available:
R
Show outbox
R
Screen activation for incoming message
R
No signalisation of new messages
R
Hide empty fields
Show outbox
You can use this function to show messages
that are in the outbox. If "Show outbox" is not
activated, the outbox is not shown in the por-
tal.
X
In the Show
outbox menu, tick O or untick
the box.
X
Press the ÷ button to confirm.
Activating the screen when receiving
messages
If the screen is switched on (Y page
11), it
fades out automatically after a certain period
of time. You can adjust the settings so that
the screen switches on again when a mes-
sage is received.
14
DispoPilot settings
Overview and operation