FF20 IH EN 74-215-051 v1.02.doc Version: 1.02 Page 4 of 21
2.4 Caution and employee safety
This manual should be read before using the FF20.
It is strongly advised that:
• Power is disconnected and secured before any kind of maintenance or cleaning of the machine is
carried out.
• Unauthorised / non-trained personnel should not open any cover or maintain the electrical parts.
• The machine much be placed on a stable bed plate and in such a way, that it is not exposed to
high humidity, high temperatures or other abnormal operating environment. It is not to be used in
explosion hazardous environment.
• Always remember that the FF20 must be earthed through the power supply plug.
2.5 Essential training before daily use
Read the section with Daily Use, thoroughly before using the machine.
Protective equipment and protective devices are installed:
• If fingers are placed in front of the inlet bottle sensor, the bottle ejector will move automatically.
If the ejector meets too much resistance, it will return to start position.
• In manual mode the ejector will not move back.
To protect operator fingers from damage the railing is spring loaded so it will be pushed back.
• Always respect the warning symbols on the machine.
• Cleaning must be performed as described in this Instruction Handbook.
2.6 References
N/A
2.7 Dismantling and disposal
Prior to dismantling, it must be observed that all services are disconnected, and connections to other
equipment are removed.
The machines must be collected and disposed separately as they may contain
electrical components such as batteries, electrolyte capacitors, liquid crystal
displays and printed circuit boards.
Further information is available on www.wmflexicon.dk.
To Next Page
Loading...
