© 2015 I-View Now, LLC. All Rights Reserved.
Flir M3200/M4200 Series Installation Guide rev 1.0 Page 13
Alarm Input Setup
Alarm inputs are to be configured to send SMTP notification to I-View Now whenever an alarm event occurs. I-View Now
suggests recording on all camera channels whenever an alarm event is detected.
From the Main Setup Menu click on the Hammer and Screwdriver and choose
EVENT
Click the “Alarm” Tab
Select Alarm In All or the
Appropriate Channel
Check the Enable Box
Set Type Normal Open
Set anti-dither 5
Set Latch 10
Check Send Email
Check Channels
Set Post_REC to 10
Optionally check buzzer
Checking buzzer makes the DVR
Beep when an alarm input is fired
To Next Page
Loading...
Need help?
General
