© 2015 I-View Now, LLC. All Rights Reserved.
Flir M3200/M4200 Series Installation Guide rev 1.0 Page 14
Configure I-View Now Entry Delays
Entry Delays are configurable through the I-View Now Dealer Portal. Log in to configure. NOTE: Entry delay takes a
physical contact. For example if the DVR/NVR has 16 cameras and one Entry delay, you will only be able to Video Verify
15 cameras.
Test Settings
Once the DVR has been properly configured and the necessary settings entered into the i-viewnow.com portal, it is a
good idea to test each alarm input on the DVR by triggering the corresponding device on your alarm panel.
If relay 1 is connected to input 1 on the DVR and it is supposed to trigger when a panic button is pushed, ensure not only
that the DVR has received the signal. Also ensure that the I-ViewNow.com portal has received the signal and correctly
identifies the type of alarm.
To Previous Page
Loading...
Need help?
General
