User Interface Menus
5
• Temperature units selection: Select ℃ or ℉.
Figure 5.26 Selecting temperature units of measure
• Emissivity selection: Select an emissivity preset or choose a custom set-
ting. See screen examples below:
Figure 5.27 Selecting the Emissivity
• IR Temperature & Moisture Alarms: Set the Temperature Alarm to
ABOVE, BELOW, or OFF. When a Temperature alarm is set to ABOVE or
BELOW, the MR277 will alert you when the temperature exceeds the high
limit (temperature display turns red) or falls below the low limit (temperature
display turns blue). When a Temperature alarm is set to OFF, the alarm is
disabled.
Set the Moisture Alarm to ABOVE or OFF. When a Moisture alarm is set to
ABOVE, the MR277 will alert you when the moisture measurement ex-
ceeds the high limit (moisture reading turns red and beeper sounds, if en-
abled). When a Moisture alarm is set to OFF, the alarm is disabled. The
Moisture alarm utility also allows you to select BEEP or NO SOUND for the
alarm alert. See Section 7.9 High Moisture Alarm and Section 8.4 High/
Low Temperature Alarms for more information.
#NAS100005; r. AL/76939/76957; en-US
20
To Next Page
Loading...
