Flo CoRe+ Max - Before Getting Started

35
6.4.2. Before Getting Started
Follow the steps below before getting started:
CAUTION: Before getting started, cut off the current to prevent an electric shock.
1. Make sure to remove the security screw used to hold the counterweight during transport when unpacking
the cable management system.
2. Install a cable management system on a new station OR install a cable management system on an existing
station by following the steps below:
6.4.2.1. Before Installing a Cable Management System on a New Side-
by-Side Charging Station Installation
1. First, install the pedestal and charging station. Refer to the Installing the Pedestal and
Charging Station section ( section 5. ) for more information and the CoRe+ MAX Installation Guide as
needed.
2. Then, prepare the installation material for the side-by-side charging station mount brackets
and cable management systems and follow the instructions in the Cable Management System
Installation section below.
CAUTION: Before getting started, cut off the current to prevent an electric shock.