Flo CoRe+ - Wall mounted installation

CoRe+
TM
Cable management system and pedestal installation guide
5
www
Wall mounted installation
Specic Tools or Material Required
• Wall attachment hardware material (¼ in diameter screw, washers and wall anchors as required)
BEFORE GETTING STARTED
! When unpackaging the Cable management system, make sure to remove the security screw
used to hold the counterweight during transport.
¡
Installing a new charging station and a Cable management system.
First, install the charging station. Refer to the CoRe+
TM
Installation Guide. Then, install the Cable
management system as indicated on the following page.
¡
Installing a Cable management system on an existing wall mounted charging station.
Install the Cable management system as indicated on the following page.
Included material Qty
Wall mounted cable management system columns and cable clamp
1
Lower wall mount bracket
1
Upper wall mount bracket
1
Spacing shims
2
Self-adhesive rubber band 6 in X 13/8 in
1
¼-20 x 2¾ screw, ¼-20 bolt and Split lock washer
1