13
3.5 Panel Mounting
Mounting of the instrument in a panel requires a 95mm x 76mm (3.75” x 3.0”) rectangular
hole to be cut in the panel – panels thicker than 3.2mm (1/8”) should substitute longer screws.
The enclosure gasket must be used to maintain weather protection when panel mounted. It is
possible to maintain the IP65 rating for the outside of the panel with an accurately cut hole
and a flat/smooth panel.
The rear enclosure of the instrument should be mounted behind the panel to protect the
electronics module from damage and provide separation from any conductive components
inside the panel/cabinet. However, it should be noted that once panel mounted the rear of
the enclosure is no longer protected from water ingress.
To Next Page
Loading...
