Safety Instructions
22
14/03/2023 212601
Attention
Danger due to inadequate lighting.
The operator of the machine must ensure that there is adequate lighting to
operate the machine.
Attention
Danger due to sharp-edged swarf.
Do not remove swarf with your bare hands.
The blowing out with compressed air is also unsuitable, since the swarf can
easily get into the eye.
Always use a suitable tool (swarf removing hook and hand brush).
Attention
Danger due to overuse of the cutters.
Observe the specifications of the cutter manufacturer with regard to the per-
missible technical characteristics (material to be machined, speed, feed, cool-
ant, maintenance and care).
An overuse of the cutter can lead to breakage and thus damage to the cutter
and the machine.
Note
Check all screw connections before commissioning the machine
Tight fit
Externally visible damage.
2.2.3 Maintenance and Repair
Danger
Danger due to hot machinery and components.
Make sure that the machine has cooled down.
Wear appropriate protective clothing.
To Next Page
Loading...
