Flowserve Limitorque MX-05 User Manual

iii
Limitorque MX Maintenance and Spare Parts FCD LMENIM2314-00 – 07/08
flowserve.com
5.3 Installation and Removal of SMT Controls
(most units supplied after September 2003 and before September 2007) 105
5.3.1 Installation 105
5.3.2 Removal 108
5.3.3 Fuse Replacement 108
5.3.4 Control Module Return Options 108
5.4 Mounting of SMT Controls with 54-point terminal block and four LED configuration
(some units supplied from December 2006 with majority after September 2007) 109
5.4.1 Installation 109
5.4.2 Removal 110
5.5 Mounting of Standard and Optional Controls with 54-point terminal block and four LED configuration 111
5.5.1 Installation 111
5.5.2 Removal 114
5.6 Adding Electronic Options to Your MX Actuator(Most Supplied After September 2007) 114
5.7 Restoring Power to Actuator with New Control Module 115
5.8 Terminal Block (prior to March 2007) 115
5.8.1 Removal 116
5.8.2 Remounting 118
5.9 MX Terminal Block (Supplied With Most Actuators Since March 2007) 120
5.9.1 Terminal Block Shield Installation 120
5.10 Control Module-Contactor Assembly (Not required for most actuators shipped after September 2007.
Please see Section 5.4 for power board installation with contactor.) 121
5.10.1 Removal 122
5.10.2 Remounting 123
5.11 Replacing 19 Amp Reverser on the MX-140 and -150 (Not for most actuators shipped after September 2007) 125
5.12 19 Amp Power Assembly for Units Shipped After September 2007 128
5.13 Encoder (Through hole and surface mount technology, most units prior to September 2007) 129
5.13.1 Removal 130
5.13.2 Remounting 132
5.14 Encoder Drive Cartridge (Most units prior to September 2007) 133
5.14.1 Removal 134
5.14.2 Remounting 135
5.15 Removal and Replacement of MX Encoder (Supplied With Most Actuators Since September 2007) 136
5.15.1 Removal 137
5.15.2 Remounting 137
5.16 Encoder Drive Cartridge (Supplied With Most Actuators Since September 2007) 138
5.16.1 Removal 139
5.16.2 Remounting 140
5.17 Motor Lead Harness (MX-85, -140, and -150) 141
5.17.1 Removal 141
5.17.2 Remounting 142
5.18 Solid State Motor Reverser Upgrade Instructions (Most units prior to September 2007) 143
5.18.1 Disassembly Procedure 144
5.18.2 Assembly Procedure 145
5.19 Mounting of SSMR (Solid State Motor Reverser) in units shipped after February 2008 147
5.20 Complete Conversion to SMT Controls 149
Swanson Flo | 800-288-7926 | www.swansonflo.com

Flowserve Limitorque MX-05 Specifications

General

Brand	Flowserve
Model	Limitorque MX-05
Category	Controller
Language	English