Flowserve M Series - Nameplate and Warning Labels

M SLURRY USER INSTRUCTION ENGLISH 71569241 - 02/08
Page 8 of 60
®
occur if there is heat input to the liquid. This can occur
if the pump is stationary or running.
Bursting of liquid containing parts due to freezing must
be avoided by draining or protecting the pump and
ancillary systems.
Where there is the potential hazard of a loss of a seal
barrier fluid or external flush, the fluid must be
monitored.
If leakage of liquid to atmosphere can result in a
hazard, the installation of a liquid detection device is
recommended.
1.6.4.7 Maintenance to avoid the hazard
CORRECT MAINTENANCE IS REQUIRED TO
AVOID POTENTIAL HAZARDS WHICH GIVE A RISK
OF EXPLOSION
The responsibility for compliance with maintenance
instructions is with the plant operator.
To avoid potential explosion hazards during
maintenance, the tools, cleaning and painting materials
used must not give rise to sparking or adversely affect
the ambient conditions. Where there is a risk from
such tools or materials, maintenance must be
conducted in a safe area.
It is recommended that a maintenance plan and
schedule is adopted. (See section 6, Maintenance.)
1.7 Nameplate and warning labels
1.7.1 Nameplate
For details of nameplate, see the Declaration of Conformity.
1.7.2 Warning labels
WARNING
MECHANICALSEALFITTED
DONOTADJUSTPUMPCLEARANCEWITHOUT
REFERENCETOMANUFACTURER’SINSTRUCTION
MANUAL
WARNING
BEFORESTARTINGTHEPUMPONSERVICE,CHECK
TOENSURECORRECTROTATIONOFMOTOR.
FAILURETODOTHISCOULDRESULTINSERIOUS
DAMAGETOTHEEQUIPMENT.
MECHANICAL SEAL WARNING ROTATION WARNING
P/N 2113931-001 P/N 2113932-001
WARNING
BEFOREGROUTING,REALIGNTHISUNIT
RECHECKALIGNMENTBEFORESTARING,
FAILURETODOTHISCOULDRESULTIN
SERIOUSDAMAGETOTHEEQUIPMENT.
REFERTOINSTALLATIONMANUALAND,OR
COUPLINGINSTRUCTIONSFORMETHODOF
CHECKINGALIGNMENT.
WARNING
THESEEYEBOLTS
ARETOBEUSEDFORLIFTINGBEARING
CARTRIDGEANDSHAFTONLY.
DONOTUSEFORLIFTINGENTIREUNIT.
GROUT WARNING LIFTING WARNING
P/N 2113934-001 P/N 9901701-001