E119-P
Page 22 FW_E119-P_M_v0301-02_EN
SELECT-key + CLEAR-key
The combination of the SELECT-key and CLEAR-key is used to select a negative
value. When a value can also be entered as a negative number, pressing the SELECT-
key and CLEAR-key simultaneously will toggle the ‘–‘ (minus) sign on and off.
Step 2b: Change the selection in a list
SELECT-key
This key is used to select the next item in the list (e.g. L à m³ à USGAL).
At the end of the list, the selection will wrap around to the first selection.
CLEAR-key
This key is used to select the previous item in the list (e.g. USGAL à m³ à L).
At the bottom of the list, the selection will wrap around to the last selection.
Step 2c: Change a line of text
SELECT-key
This key is used to scroll though the list of available characters. The following character
set is available through the control panel: ", *, –, 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D, E,
F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z.
When a line of text is programmed via the Remote Configuration Software, a larger
character set with ASCII codes 32 through 127 is available. When a character is
programmed that cannot be shown on the display, that character is indicated by turning
all segments on. When the character is changed by pressing the SELECT-key, it will
return to the character set indicated above and the original character is lost.
CLEAR-key
This key is used to select the next character. When the end of the line is reached, the
selection will wrap around to the first character (e.g. character 1 à character 2 à
character 3 à character 4 à character 1).
The currently selected character will be flashing; when the selected character
represents a space, it will alternate with an _ (underscore).
● Since the LCD is not suitable to display all characters, a character that cannot be shown is
indicated on the LCD with all segments turned on (resembling the number 0 and * (asterisk)
combined).
● A blinking underscore _ represents a space, not an underscore!
● When the signs < or > are shown on the display, this indicates that more characters are
available to the left and / or to the right of the currently shown text.
● Press the CLEAR-key for 3 seconds to clear the entire line of text.
● Press the PROG-key for 3 seconds to cancel any changes.
Step 3: Finish the programming sequence
PROG-key
During the programming sequence, this key is used to confirm the new value and
return to SETUP mode. To cancel the operation, either press the PROG-key for 3
seconds or wait for 20 seconds: the programming sequence is cancelled and the
former value is reinstated.
5.3.4 RETURNING TO OPERATOR MODE
When all configuration settings are set correctly, return to OPERATOR mode by pressing the
PROG-key for three seconds, or do not press any key for 2 minutes to return automatically. The
indicator is now activated on the display and the
indicator is deactivated.
To Next Page
Loading...
Need help?
General
