Fluke 1537-II - Tester On;Off

5
Insulation Tester
The Tester
Also use to access these menu items:
• Voltage adjustment in 100 V for each step
• Time limit xx-xx
• T - 0 to 99 minutes
T1, T2, T3 - T1 < T2 < T3
T1 > 0 seconds, T3 <1000 seconds
• Show test parameters
• Change the name of the ID tag for the test result
• Push
to make the selection.
Tester On/O󰀨
Push to turn on the Tester.
The Tester does a self-check, shows the software version, and starts in the
Insulation Resistance Idle mode.
In Insulation Resistance Idle mode:
• Change test parameters
• Start an insulation test
• View stored test results (1537/1537-II only)
• Download test results (1537/1537-II only)
W
Caution
If the object under test is highly capacitive, it can take a long time
for the Product to discharge. Do not turn o󰀨 the Product or remove
test leads until the discharge is complete.
When on, push >1 second to turn o󰀨 the Tester.