Fluke 1537-II - Store Test Results (1537;1537-II Only); View Test Results Stored in Memory (1537;1537-II Only)

19
Insulation Tester
Insulation Test
Store Test Results (1537/1537-II only)
When the insulation test is done, the Tester shows a prompt to save the results.
The Tester memory stores the results of up to 99 insulation tests.
To store the results of an insulation test:
1. Push
to save the measurement results. The Tester assigns and displays a
sequential tag number to identify the measurement.
2. If the tag number is acceptable, push
to store the data. If a di󰀨erent tag
convention is required, create a custom 4-character tag:
a. Notice that the active character is blinking on the display. This is the rst of
the four characters available for tagging the test results. Repeatedly push
to cycle through the character positions.
b. At each character position use
or to assign a character (0-9, A-Z, a-z).
c. Push
to store the results.
View Test Results Stored in Memory (1537/1537-II only)
Note
Parameters not appropriate for a test are shown as NA or UNSPEC.
The Tester can store 99 sets of test data, including:
• Tags
• Ramp on or o󰀨
• Insulation Resistance
• Timer reading at termination of test (Timer)
• Test Voltage Selected (TV)
• Actual Test voltage (V)
• Capacitance (C)
• Polarization Index (PI)
• Dielectric absorption ratio (DAR)
• Dielectric discharge (DD)
• T1, T2, T3 (time, voltage, current and resistance.)
• Test current (I)
• Reason for ending the test
• Limit – o󰀨 or timer setting (1 to 99 minutes) (T. Limit)