1630-2/1630-2 FC
Users Manual
10
Time/Clock
The Clamp has a time setting that is used as a timestamp for
logged data.
To check or adjust the time setting:
1. Push until TIME shows in the display. See Figure 3.
2. Push until the digit you want to change starts to blink.
3. Push / to increment/decrement the value of the
blinking digit.
4. After you select the value, push until the digits stop
blinking.
5. Push
to go back to the measurement mode.
Figure 3. Time Setting
Clamp Settings
The Clamp has a Setup menu for these subfunctions:
•
Backlight auto-off
•
Power auto-off
•
Firmware version
Backlight Auto-Off
A backlight on the display improves visibility in dim light. To
conserve battery power, turn off the backlight.
To change the backlight option:
1. Push until : shows on the display. See Figure 4.
2. Push / to toggle the setting between on and off.
The display updates to show the current setting:
•
On: backlight turns off after 2 minutes
•
Off: backlight does not turn off
Figure 4. Backlight Setting
3. Push to confirm the current input and move to the
next setting.
4. Push
to go back to the measurement mode.
To Next Page
Loading...
Need help?
General
