1630-2/1630-2 FC
Users Manual
16
Logging Measurements
The Clamp records data over time and saves >2000
measurements in memory at the set logging interval.
To start logging measurements, push . The display shows
to indicate that measurement logging is in progress See
Figure 10.
Figure 10. Logging Measurements
Measurements are recorded at the sampling interval you
specified. See Log Interval on page 8 for more information.
Logging stops when:
•
Clamp memory is full
•
Clamp detects a low battery
•
You push again
Note
If the sampling interval is set at 0 seconds, only one
data point is recorded. To record the next data point,
press again. The memory location is also
displayed for about 1 second.
Hold
Push to freeze the measurement value on the display.
Push again to continue and take measurements.
Filter
Push to toggle the filter on and off in the leakage current
measurement mode. When shows on the display, the
clamp can isolate the 50/60 Hz fundamental frequency from
the harmonics.
To Next Page
Loading...
