ntroduction
9 Toggles
between
autorange and loc ked ra nge in MEASURE
mode, and
increments range.
Each time you press l
SANat
l
,
the calibrator locks
on the next
higher
range. Press
this
key again for 2 seconds
to resume autorange.
1
0
Clears
a partial data entry or zeros the output
when in the SOURCE
mode.
11 Use to
adjust the display contrast.
Also, use to make selections
when
prompted. These
keys also increment or
decrement the sourced
output in
steps.
12 Terminates
a numeric entry when
setting a source value, or
selects entries
from
lists.
13 Toggles
between resistance and continuity
functions in MEASURE
mode, or
selects
the resistance function in
SOURCE mode.
1 4 Use whenever
a numeric entry is required.
15 Toggles
between ac voltage
and frequency functions in the MEASURE
mode,
or
selects frequency output
in
the
SOURCE mode.
1
6 Selects the dc voltage function
in the MEASURE mode, or selects
dc voltage
in
the SOURCE mode.
To Next Page
Loading...
