Fluke 702 - Loop Power

Loop Power
Loop Power
With the loop power
function,
you can test a transmitter before
you install it or
when it is disconnected
from plant wiring. You
can use loop power in
MEASURE,
SOURCE, or MEAS
UR E/SOURCE
mode. Turn loop power on
and off from the
l
SETUP
!
menu.
1
. Connect the calibrator
to
the
transmitter current loop terminals.
2.
jsitupp
3. to highlight Disabled
after Loop Power,
f
enter
| ,
4. Select Enabied-24V
for 24V operation, or
Enabled-28V for 28V operation.
NOTE
Most transmitters
are designed for 24V
operation, but some installations
may
require
28V.
5. |
ENTER
|.
6. To measure
loop currentatthe
same time thatyou are supplying
loop power,
press
r™*! in MEASURE
mode.
25