Fluke 702 - Keys

Introduction
Keys
1
Turns the power on
and off.
2
Cycles the calibrator
through
MEASURE,
SOURCE,
and
MEASURE/SOURCE
modes.
3
Selects mA
(current)
measure
or
source
function.
For
loop
power on/off, go
to the
i
SETUP
i mode.
4 Enter and
exit the
mode
to modify
operating
parameters.
5
Perform
the function
defined by
the
label above
each key
on the
display.
6
Turns the
backlight on
and off.
7 Selects the
pressure
measurement
function.
8
Selects
TC
(thermocouple) or
RTD
(resistance
temperature
detector)
mea-
surement
or sourcing
functions.