Fluke 702 - Using Source Mode; Sourcing Electrical Parameters

Using Source Mode
Using Source Mode
Press SsoSbIeI
until the calibrator
is in SOURCE mode. The word SOURCE
shows
in the
mode indicator bar atthe top
of the display. You must be in
SOURCE mode
to change
source or simulate
parameters.
Sourcing Electrical
Parameters
1
.
Connect
the calibrator
to the load as shown.
2. Eouwd for SOURCE
mode.
3.
GntD,
(vE),
CED,
or
HD.
(For Oja]
select source mA or simulate
transmitter,
i.e. regulate current.)
4. Numerical value.
Example,
(DO®.
5. |
enter”)
.
I
mA
11