Fluke 702 - Generating a Frequency; Simulating Thermocouples

Using Source Mode
Generating
a Frequency
1
.
Connect
the calibrator
as
shown
on previous page.
2.
SiES
for SOURCE mode.
3.
IS.
4.
Enter the signal amplitude
and
frequency.
The
calibrator will supply
a
square
wave.
Simulating
Thermocouples
1
. Connect the calibrator to the instrument under test with thermocouple wire
and the appropriate thermocouple minijack as shown.
2.
SMH3
for
SOURCE mode.
3.
rsn
.
4.
to select the desired thermocouple type.
5. r
ENTER
6. Enter the desired
temperature.
7.
j
enter"]
.
12