87V Ex
Users Manual
14
Table 5. Display Features (cont.)
Number Feature Indication
M
A, µA, mA
Amperes (amps), Microamp, Milliamp
V, mV
Volts, Millivolts
µF, nF
Microfarad, Nanofarad
nS
Nanosiemens
%
Percent. Used for duty cycle
measurements.
e, Me, ke
Ohm, Megohm, Kilohm
Hz, kHz
Hertz, Kilohertz
AC DC
Alternating current, direct current
N
°C, °F
Degrees Celsius, Degrees Fahrenheit
O
610000 mV Displays selected range
P
HiRes
The Meter is in high resolution
(Hi Res) mode. HiRes=19,999
Auto
The Meter is in autorange mode and
automatically selects the range with
the best resolution.
Q
Manual The Meter is in manual range mode.
Number Feature Indication
R
The number of segments is
relative to the full-scale value of
the selected range. In normal
operation 0 (zero) is on the left.
The polarity indicator at the left of
the graph indicates the polarity of
the input. The graph does not
operate with the capacitance,
frequency counter functions,
temperature, or peak min max. For
more information, see “Bar
Graph”. The bar graph also has a
zoom function, as described under
"Zoom Mode".
--
0L
Overload condition is detected.
Error Messages
bAtt Replace the battery immediately.
diSC
In the capacitance function, too much electrical
charge is present on the capacitor being tested.
EEPr
Err
Invalid EEPROM data. Have Meter serviced.
CAL
Err
Invalid calibration data. Calibrate Meter.
LEAd
WTest lead alert. Displayed when the test leads are
in the A or mA/µA terminal and the selected rotary
switch position does not correspond to the terminal
being used.
To Next Page
Loading...
